Manufacturer of water pump pressure tank, brand HYDROLINE BEV, 750 liters l HRR

Inside the tank is a diaphragm rubber filling made from a single piece of natural rubber filling. Can be removed and replaced And there is air added to the tank to start the pump, how many bars to start and cut off at how many bars. Most of them are based on the Start pressure and will be set to 3-5 PSI lower.

The tank has a vertical shape and is machined with standard strength. and coated with paint Can be used with all types of water or water that is highly corrosive.
Bucket with rubber filling Can hold more pressure than a pressure tank without a rubber filling.
The rubber filling is made from a single piece of natural rubber. Can be removed and replaced
The rubber filling has a secure installation point.
Factory produced tanks There is complete separation between air and water.
The pump and accessories can be mounted directly to the tank.
It can be assembled economically and quickly.

Installed for use in conjunction with Booster Pump, pumps and various accessories for use with residences, tall buildings or areas that need to use a large amount of water.
Additional system to increase water pressure
Residential and commercial water supply systems
irrigation system
Fire water supply system
HVAC supports expansion

Calculation. Determination of tank capacity. It depends on the water pressure, tripping pressure and effective water reserve. (See the catalog for calculation information)
A larger tank will have a greater amount of water stored between high and low pressure. which means You will have enough water. before the pump starts working larger tank It will help the pump turn on and off cycle for a long time. and work longer This will increase the life of the pump.
Ps = Start up pressure – (Pump Start) / Ps = Shut off pressure – (Pump Start)
Ps = starting pressure (Pump starts working)
Ps = maximum pressure required When the flow is stopped (Pump stops working)

Suggestions on checking and taking care of equipment

Check the Start-Stop operation of the pump system. How much is the pressure?
Close valve No.1 and then open valve No.2 to completely drain out the water in the Frankan tank.
Always check the air inside the pressure tank every 3 months to keep the values inside the pressure tank the same. and does not cause problems to the system
If the value read from the tire pressure measuring device The reading is much lower than the starting point. Add more air. But if there is more than the Start point, remove the air.
Use a tool to measure the air in general car tires. To measure the air in the tank at the air filling valve. If a large amount of water comes out while pressing indicates that the diaphragm rubber filling may be damaged.
If you find that you have encountered a problem that cannot be fixed by yourself, such as a tank with a leak, a broken rubber filling, or other damaged locations. You should consult with Expert team to receive immediate corrections