ไทย
H.Pattanarungrueng Co., Ltd. is a specialist in the design and manufacture of Pressure Diaphragm Tank Hydroline 24 Liter solely under the brand “Hydroline” Products meet international standards along with systematic management thus making business operations more efficient and complies with ISO 9001 : 2015 standards.
Standard Model HYDROLINE “Pressure Diaphragm Tank”
Specification
- 24 Litres
- Precharge Pressure (PSI) 25
- Max. Working Pressure (PSI) 87
- Dimension D(mm) 300 x H(mm) 570
- Connection 1″
Exterior material
- Made from SPHC sheet steel.
- blue glaze.
Inner material
- Inside the tank is a diaphragm filament made from a single piece of natural rubber filament. can be replaced And there is air filling into the tank to start the pump, how many bars to start and how many bars to cut off. In most cases, it is based on the Start pressure and will be set below 3-5 PSI.
Type
- The hull is vertically shaped and molded with strength as standard. and color plating Can be used with all types of water or very corrosive water.
- bucket with rubber filling Can hold more pressure than a pressure tank without filling.
- The filling is made from a single piece of natural rubber can be replaced.
- The filling has a solid mounting point.
- factory-made tanks It has complete separation between air and water.
- The pump and accessories can be mounted directly to the tank.
- Quick and economical assembly.
Type of use
- Install applications in conjunction with Booster Pumps, pumps and various accessories. Use with residences, high-rise buildings or areas that require a lot of water use.
- Additional system to increase water pressure.
- Residential and commercial water supply systems.
- Irrigation system.
- Fire water supply system.
- HVAC supports expansion.
Restrictions on use
- Temperature 5-90 c.
- The maximum pressure is 10 bar.
Introduction
- Calculation Determination of the capacity of the tank depending on water pressure tripping pressure and effective water reserve (See the calculation data in the catalog).
- The larger the tank the more water is stored during high and low pressures which means you will have enough water before the pump starts larger tank It allows the pump to turn on and off for a long time and work longer this will increase the service life of the pump.
- Ps = Start up pressure – (Pump Start) / Ps = Shut off pressure – (Pump Start).
- Ps = Starting pressure (Pump starts working).
- Ps = maximum pressure required when the flow is stopped (Pump stops working).
Product warranty
- 1 year
Suggestions about checking and taking care of equipment
- Check the Start-Stop of the pump system whether What is the pressure at.
- Close the No.1 valve and open the No.2 valve to completely drain the water in the Frank tank.
- Regularly check the air inside the pressure tank every 3 months to keep the pressure inside the pressure tank the same. and not send problems to the system.
- If the value read from the tire pressure gauge Reads much less than the Start point, add more air but if there is more than the start point remove the air.
- Use a general tire pressure gauge to measure the air in the tank at the kiss fill the air If a large amount of water comes out while pressing Indicates that the rubber diaphragm filler may be damaged.
- If found that there are problems that cannot be solved by yourself such as a leaking tank broken rubber filling or other damaged positions Should consult with expert team to be corrected immediately.
