Maintenance to extend the lifespan of water pump It’s not difficult If you follow these techniques, you are guaranteed to end unnecessary frequent repair problems.
Problems with the operation of the water pump stuck most often encountered with inadequate care or lack of experience In the matter of the preliminary check or use in the wrong way do you often encounter these things? If the customer thinks it might be too difficult or don’t dare try to fix it don’t let that opportunity slip away because of checking and checking actually it’s easy let’s see how to inspect and maintain water pumps to be able to use it for a long time with this article.
By general care must observe and check the following values
1. The operation of the control whether it works abnormally or not, such as various light bulbs every time you check the control, the power light bulb must always show or the over load light bulb shows, indicating that the pump has a problem hurry and check it immediately and check the status of the light bulbs on the control page.
2. Listen to the motor to see if it doesn’t make any unusual noises from what was previously checked.
3. Observe the seal on the neck of the pump to see if there is any water leakage or not.
Pump inspection and maintenance procedures
So that the pump has a long service life and you don’t have to stop working frequently for repairs every pump there should be a history book of use and maintenance as well as having a definite schedule for inspection and maintenance lnspection and maintenance dvided into daily inspections Inspection every 6 months and annual inspection.
Daily inspection and maintenance are as follows
1. Temperature of the slip liner
2. Pressure through the suction and discharge pipes
3. Leakage from the seal (seal)
4. Lubrication of the seal by looking at the glass tube or other indicators
5. Load (Load) of the electric motor
6. Level of noise and vibration
7. Level of lubricating oil used to maintain the slippery support
Inspection and maintenance every 6 months are as follows
1. Getting alignment between the pump and the power source
2. Adding oil or grease the slippery support
3. Check the suction pipe for leaks
Annual inspection and maintenance are as follows
1. Leakage along the shaft and repair of leaks
2. Wear of the shaft casing
3. Space between the impeller and the wear ring
4. Test and adjust various gauges that is used to measure electric current
5. Change the lubricating oil and slippery grease
How are you? with the topic of pump inspection and maintenance just follow these few steps I can guarantee that can definitely extend the life of the water pump for all customers just pay a little attention this just makes you stop having headaches in solving various problems or if you are still wondering about the symptoms and how to check? you can go back and read this article P’Tank presented the information in tables for easy understanding for checking and basic solutions.